![]() ![]() THE PATCHING PROCESSĪfter you’ve mastered how to remove drywall anchors or recessed the smattering of fasteners out of sight, patch the remaining hole with drywall compound. Position a screwdriver wider than the anchor mouth over the anchor head, and squarely but lightly tap the screwdriver with a hammer until you sink the drywall anchor partway into the drywall. ![]() Score the drywall around the anchor head with a utility knife. Perhaps the simplest way to deal with multiple unwanted drywall anchors, or those in drywall that’s brittle or water damaged, is to recess rather than remove them altogether. Then place a screwdriver with a head wider than the anchor’s mouth, but not wider than the drywall anchor itself, and firmly tap the screwdriver until the anchor falls out behind the back of the wall. Score the drywall around the anchor head with the cutting wheel or, if you don’t have a drill with a cutting wheel, a utility knife. Then tap a wide nail against the anchor mouth with a hammer until the drywall anchor falls back behind the wall. METHOD 3: CUT AND HAMMER ITĭon protective goggles and attach a 1-inch cutting wheel to a drill. ![]() If it won’t budge, or turns but doesn’t back out, proceed to Method 3 (if you have a cutting wheel) or consider Method 4 to sink the anchor into the wall. Turn the screwdriver counter-clockwise to back the drywall anchor out. Photo: METHOD 2: BACK IT OUTĬhoose a screwdriver that will fit snuggly into the mouth of the anchor and tap it into place with a hammer. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |